So I think the firmware update has broken something. 5) Go back to main level and raise fader FX A return (the next after channel 32). 3) Go to FX A and raise fader 1 to unity. 2) Raise master fader to an appropriate level (no too loud.). The router is set just like it was before I did the firmware update, in which I case I went through these exact same steps and it connected fine. 1) Raise the fader of channel 1 to unity. ' for awhile, then scannning., then same screen as before: Same steps as above, but choosing 'WCCG Secure' for the network, Store, provide password, StoreĬomres back to main screen, saying 'joining. SO - I change to a different (password protected) network: So I go back to main screen, Recall to scan again, and choose it over again.
Password: (I clear this out by pressing Recall to reset, because there's no pass on this network) This will link the two channels as a stereo pair. Driver Version: 4.7 Universal Control AI Build: 1.8 The latest and greatest is: Universal Control (Mac/PC) with UC Surface v1. Engage USB for Channels 1 and 2 using the Numbered buttons above each channel. Press the USB button on the left side of the StudioLive. for example I did this on the console:Ĭonnected To: Ethernet (no Ethernet cable connected to console, though) By default, Windows and Mac will return Audio to channels 1 and 2 on the StudioLive. There is strange behavior on the wifi menu. I actually tried rebooting the router completely, having my laptop connected to it (not sure if this should matter - but did it), and then booted the S元2.4.2AI.
0 kommentar(er)
